La Crosse Technology WS-7075U User Manual

Page 18

ensure a secure hold. The mounting surface should
be smooth and flat.

2) Remove the protective strip from one side of the

tape. Adhere the tape to the designated area on the
back of the mounting bracket.

3) Remove the protective strip from the other side of the

tape. Position the Remote Control Sender in the
desired location, ensuring that the Indoor
Temperature Station can receive the signal.

II. THE INDOOR TEMPERATURE STATION

The Indoor Temperature Station can be mounted in two ways:

• with the table stand or,
• on the wall with the use of a wall hanging screw (not

included).

A. USING THE TABLE STAND

1) The Indoor Temperature Station comes with the table

stand already mounted. If you wish to use the table-
stand all that is required is to place the Indoor
Temperature Station in an appropriate location.

B. WALL MOUNTING

1) Remove the table-stand. To do this, pull down on the

stand from the rear and rotate forward.

2) Fix a screw (not included) into the desired wall,

leaving approximately 3/16 of an inch (5mm)
extended from the wall.

3) Place the Indoor Temperature Station onto the screw

using the hanging hole on the backside. Gently pull
the Station down to lock the screw into place.