Lenoxx Electronics CD-110 - Manual (Page 5)

CHOOSING THE POWER SOURCES
You can use the AC power or batteries as a power source.
TIP
If the plug of the AC power
cord does not match your
outlet, do not force it.
Reverse it and try again.
The plugs are polarized
and only fits one way into
the wall outlet and back of
the set.
TIP
Replace the batteries
when the POWER lamp
dims or when the player
stops operating. Replace
all the batteries with new
ones. Before you replace
the batteries, be sure to
take out the CD from the
player and remember to
check the Battery Safety
Instructions on Page 3.
1. Connecting the AC power
cord
Insert one end of the supplied AC power cord
(located in the battery compartment) into the socket
located at the rear of the player, and the other end
to the wall outlet.
2. Using the player on batteries
Insert 6 size “D” batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect the AC
power cord from the player.
4
AC SOCKET
Battery compartment
(on the bottom of the set)
To a wall outlet
NOTE: One blade of plug
and outlet is wider.
+
+
+ +
+ +
REMOVE
BATTERY
DOOR
IB-CD110(SY)-WM-E-V1