Linksys WAP2000 - Manual (Page 20)

Chapter 5 Advanced Configuration
6 Wireless-G Access Point with Power Over Ethernet
Change these settings as described here and click Apply
to save your changes. Help information is available on the
right side of the screen.
Administration > Factory Default
On this screen you can restore the Access Point’s factory
default settings.
Administration > Factory Default
Note any custom settings before you restore the factory
defaults. Once the Access Point is reset, you will have to
re-enter all of your configuration settings.
Restore Factory Defaults To restore the Access Point’s
factory default settings, follow the steps below:
Click the Yes option.
Click the Apply button.
Click OK to confirm that you want to restore the
factory default settings. Your Access Point will reboot
and come back up with the factory default settings in
a few seconds.
Administration > Firmware Upgrade
On this screen you can upgrade the Access Point’s firmware.
Do not upgrade the firmware unless you are experiencing
problems with the Access Point or the new firmware has a
feature you want to use.
1.
2.
3.
Administration > Firmware Upgrade
To upgrade the Access Point’s firmware:
Download the firmware upgrade file from the Linksys
website, www.linksys.com.
Extract the firmware upgrade file on your computer.
On the Firmware Upgrade screen, enter the location of
the firmware upgrade file in the field provided, or click
the Browse button to find the file.
Click the Apply button, and follow the on-screen
instructions.
Help information is available on the right side of the
screen.
Administration > Reboot
On this screen you can reboot the Access Point.
Administration > Reboot
This feature is useful when you need to remotely reboot
the Access Point.
Device Reboot To reboot the Access Point, click the Yes
option. Click Apply and the Access Point will reboot itself.
Help information is available on the right side of the
screen.
1.
2.
3.
4.