Lincoln 2008 MKZ - Manual (Page 68)

6. Return to the vehicle and firmly press, hold for two seconds and
release the programmed HomeLink
௡ button. Repeat the
press/hold/release sequence again and, depending on the brand of the
garage door opener (or other rolling code equipped device), repeat this
sequence a third time to complete the programming.
HomeLink
௡ should now activate your rolling code equipped device. To
program additional HomeLink
௡ buttons begin with Step 1 in the
“Programming” section. For questions or comments, please contact
HomeLink
௡ at www.homelink.com or 1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
௡ to accept the signal
from the hand-held transmitter.
After completing Step 1 outlined in
the “Programming” section, replace Step 2 with the following:
Note: If programming a garage door opener or gate operator, it is advised
to unplug the device during the “cycling” process to prevent overheating.
• Continue to press and hold the HomeLink௡ button (note Step 2 in the
“Programming” section) while you press and release — every two
seconds (“cycle”) your hand-held transmitter until the frequency signal
has been accepted by the HomeLink
௡. The indicator light will flash slowly
and then rapidly after HomeLink
௡ accepts the radio frequency signal.
• Proceed with Step 3 in the “Programming” section.
Operating the HomeLink ா Wireless Control System
To operate, simply press and release
the appropriate HomeLink
௡ button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry door
lock, or home or office lighting etc.).
For convenience, the hand-held
transmitter of the device may also be
used at any time. In the event that there are still programming difficulties,
contact HomeLink
௡ at www.homelink.com or 1–800–355–3515.
2008 MKZ (378)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
68