Life Fitness X8 - Manual (Page 38)

35
S TRIDE L ENGTH A DJUSTMENT N OT W ORKING
Turn off the cross-trainer’s power. Turn the power back on after 30 seconds and try the stride adjustment again.
S TRIDE L ENGTH IS A UTOMATICALLY C HANGING
Check to see if the Leg Sculptor mode is turned on. When on, the Icon Leg Sculptor key is illuminated. The Leg Sculptor
automatically adjusts the stride every 2 minutes during a workout. To turn the Leg Sculptor mode off press the Leg
Sculptor key.
S TRIDE A DJUSTMENT S EEMS L OUD
Some noise is normal. The sound of the motors will vary depending on the load.
S TRIDE L ENGTH F EELS L ONGER ON O NE S IDE
Turn the unit off. Turn the unit on after 30 seconds and check to see if the stride length still feels longer on one side.
T
OTAL
B
ODY
A
RMS
F
EEL
L
OOSE
Remove the moving arm pivot covers and check to make certain the bolt holding the total body arms in place is fully
tightened. If the total body arms still feel loose, you may need to disassemble the total body arms and make sure all of
the proper hardware from the assembly instructions was used.
A
CTIVITY
Z
ONE
K
EEPS
T
URNING
O
FF
The activity zone is preset to turn the backlight off after 5 minutes in order to save power and LCD life. If you would like
the display to always be turned on sleep mode can be turned off in the settings menu.
W HEN A CTIVITY Z ONE T URNS O FF THE S TRIDE C HANGES
The stride will always return to the home position of 18 inches (46 cm) when entering sleep mode. This is so the next
time you get on the cross-trainer it is at its lowest position. Sleep mode is a setting that turns the display backlight off to
save power and LCD life. It is preset to 5 minutes. If you would like the display to always be turned on, sleep mode can
be turned off in the settings menu.