Troubleshooting & repair, 20 volts 2ms ch1 – Lincoln Electric SQUARE WAVE TIG 255 SVM100-A User Manual
Page 76
SQUARE WAVE TIG 255
F-35
TROUBLESHOOTING & REPAIR
TYPICAL OUTPUT VOLTAGE WAVEFORM - MACHINE LOADED
DC TIG MODE
CAUTION
HIGH VOLTAGE / HIGH FREQUENCY can damage test equipment.
• Perform all voltage and waveform checks with high frequency circuit OFF.
_____________________________________________________________________
0 volts
20 volts
2ms
CH1
This is a typical DC (+) output voltage wave-
form generated from a properly operating
machine. Note that each vertical division
represents 20 volts and that each horizontal
division represents 2 milliseconds in time.
The machine was loaded with a resistance
grid bank. The TIG 255 display read 200
amps at 50VDC.
Note: Scope probes connected at machine
output studs: (+) probe to electrode, (–)
probe to work.
MACHINE LOADED TO 200 AMPS AT 50 VDC
Volts/Div................................20 V/Div.
Horizontal Sweep .................2 ms/Div.
Coupling .........................................DC
Trigger .....................................Internal
SCOPE SETTINGS