LG LHX-557 - Manual (Page 47)

47
Operation
Additional Features
SCREEN SAVER
The screen saver appears when you leave the Home
Theater System in Stop mode for about five minutes.
If the Screen Saver is displayed for five minutes, the
Home Theater System automatically turns itself off.
VIDEO MODE SETTING
The video mode setting only works when the
Progressive Scan mode is set to “On” in the Setup
menu.
• With certain discs, the playback picture may be
flickering or Dot Crawl is shown on straight lines.
That means Vertical interpolation or De-interlace is
not perfectly matched with the disc. In this case, the
picture quality may be improved by changing the
video mode.
• To change the video mode, press and hold
DISPLAY about 3 seconds during disc playback.
The new video mode number selected is displayed
on the TV screen. Check whether the video quality
has improved. If not, repeat the above procedure
until picture quality is improved.
• Video mode change sequence:
MODE1 → MODE2 → MODE3 → MODE1
• If you turn off the power, the video mode will be
back to initial state (MODE1).
Tip:
Detailed Descriptions for Video Modes
MODE1: The source material of the DVD video (film material
or video material) is determined from disc information.
MODE2: Suitable for playing film based content or video
based material recorded by the progressive scan method.
MODE3: Suitable for playing video based content with
comparatively little motion.
XTS (EXCELLENT TRUE SOUND)
You can enjoy the vivid stereophonic sound of the
digital original source without any signal distortion.
Each time you press XTS during 2 channel mode,
the setting changes in the following order.
XTS- 1 → XTS- 2 → XTS- 3 → XTS OFF ...
Tips:
XTS- 1: When playing the movie with the weak
bass sound relatively to the general
music, it enforces the sense of sound at
woofer for you to satisfy with.
XTS- 2: In the mode of 2 CH BYPASS, It creates
the high display effect by playing the
sound source via the rear speakers same
as the front speakers.
XTS- 3: You can operate both XTS- 1 and XTS- 2
simultaneously and it can complement the
relative degrading of the sound pitch of the
woofer at the XTS- 2 mode.
Note:
The XTS- 2 mode is temporarily disabled when changing
from 2.1 CH to 5.1 CH and it is enabled when changing it to
2.1 CH.