Lathem TRUALIGN TIME RECORDER 800P - Manual (Page 29)

800P TruAlign Time Recorder User Guide
Page 30
Appendix B - Calibrating the TruAlign
Function
The time recorder was calibrated at the factory but with the
passage of time or shifts in temperature you may find it
necessary to recalibrate the time recorder.
When should I calibrate the TruAlign function for
the timecard?
Recalibration may be needed if you insert a timecard in the
time recorder and the blue LED changes to green when the
timecard is not aligned correctly. See below for an example of
a timecard when the TruAlign function needs to be
recalibrated.
How to calibrate the TruAlign function
To recalibrate the TruAlign function, see the instructions
below. Note: It is recommended when performing the
calibration function to be in a sitting position with the
timeclock on a stable flat surface in an undisturbed
environment.
Enter the ‘Setup Mode’. See Page 13.
Press the SET button until you get to Function 15
TruAlign function needs to be
recalibrated. Imprint is not
lined up correctly in
timecards print area when
the green LED displays.
TruAlign function is
calibrated correctly. Imprint
is lined up correctly in
timecards print area when
the green LED displays.