Lathem TRUALIGN TIME RECORDER 800P - Manual (Page 23)

800P TruAlign Time Recorder User Guide
Page 24
Function 14 – Confirmation Beep Disable/Enable
When prompted to select whether the confirmation beep will
sound or will be disabled, use the
+
button to scroll forward
or the - button to scroll backwards. With the desired setting
showing on the display, press the SET button. The ‘TruAlign
Calibration’ function (15) will display next.
If enabled, a confirmation beep will sound after each imprint
on a timecard and also when you press the time recorder
programming buttons.
Setting Values
n = Confirmation beep disabled, this is the factory
setting
y = Confirmation beep is enabled
Example: Set the confirmation beep to enabled (y)
Step 1
Press the or
-
button until the display
shows ‘y’.
Step 2
Press the SET button when the setting is
correct. The setting will be accepted, go to
the ‘TruAlign Calibration’ function.
Note: If you scroll past the setting you wish,
continue pressing the or
-
button until
the desired setting displays, then press the
SET button.
14: y
14: n
Enable/Disable
Beep
Function #