Linksys HPN200 - Manual (Page 12)

9. Verify that your network services are correct. If you are unsure as to how
your services should be set up, consult your NT documentation. Click the
Next button.
10. The setup wizard will tell you that it’s ready to install your networking
components. Click the Next button.
11. Windows NT may tell you that it needs to copy some NT system files onto
your hard drive. If this is the case, remove the Linksys HomeLink ® CD-
from your CD-ROM drive and insert your Windows NT CD-ROM. Type
D:\i386 (where D is the letter of your CD-ROM) and click the Continue
button.
Phoneline 10M Network Card
19
6. A window will appear verifying that the Linksys HomeLink ® Phoneline
Network Adapter has been detected. Click the OK button.
7. Now you will be back at the setup wizard. You will see the HomeLink ® card
listed in the Network Adapters window. Click the Next button.
8. Select your protocols for the card.
Linksys HomeLink ® Series
18
Note : If you are using a
service pack in Windows
NT, you may be required
to re-install it after
installing the HomeLink ®
Card and driver.