Lenovo LT1952P - Manual (Page 15)

Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not
displayed.
Note: The direct access controls are colored.
Table 2-1. Direct access controls
Icon Control Description
Image Setup Activates automatic image adjustment.
Brightness Direct access to Brightness adjustment.
Using the On-Screen Display (OSD) controls
The settings adjustable with the user controls are viewed through the On-Screen
Display (OSD), as shown below.
To use the controls:
1.
Press to open the main OSD menu.
2. Use or to move among the icons. Select an icon and press to access
that function. If there is a sub-menu, you can move between options using
or
, then press to select that function. Use or to make adjustments.
Press to save.
3. Press to move backwards through the sub-menus and exit from the OSD.
4. Press and hold for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold for 10 seconds to unlock the OSD
and allow adjustments to the OSD.
Chapter 2. Adjusting and using your monitor
2-3
5. Enables DDC/CI by default. Use OSD Exit Key,Press and hold the buttons for
5 seconds to disable / enable DDC/CI function. The words " DDC/CI Disable/DDC/
CI/Enable" shows on the screen.
Input Change Switches the video input source.
press "AUTOSCAN" to go back to Auto Scan mode.
"No sync","No Cable" or "power Saving Mode".press or to
choose input signal.
6. Press "Exit Key" to enter the input Signal meun(picture 2) when the monitor is under
the condition of
(picture 1) (picture 2)