Kenwood KDC-2025 User Manual
Page 31
— 31 —
The messages shown below display your systems
condition.
EJECT:
No disc magazine has been loaded in the changer. The disc
magazine is not completely loaded.
E01
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
NO DISC:
No disc has been loaded in the disc magazine.
E02
➪ Load a disc into the disc magazine.
E-04:
No disc has been loaded in the disc magazine.
E04
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is
scratched a lot.
➪ Clean the CD and load it correctly.
E-05:
The CD is upside-down.
E05
➪ Load the CD correctly.
BLANK:
Nothing has been recorded on the MD.
E10
NO TRACK:
No tracks are recorded on the MD, although it has a title.
E11
E-15:
Media was played that doesn’t have data recorded that the
unit can play.
E15
➪ Use media that has data recorded that the unit can play.
NO PANEL:
The faceplate of the slave unit being connected to this unit
has been removed.
E30
➪ Replace it.
E-77:
The unit is malfunctioning for some reason.
E77
➪ Press the reset button on the unit. If the "E-77" code does
not disappear, consult your nearest service center.
E-99:
Something is wrong with the disc magazine. Or the unit is
malfunctioning for some reason.
E99
➪ Check the disc magazine. And then press the reset button
on the unit. If the "E-99" code does not disappear, consult
your nearest service center.
HOLD:
The protective circuit in the unit activates when the
temperature inside the automatic disc changer exceeds 60°C
(140°F), stopping all operation.
E0d
➪ Cool down the unit by opening the windows or turning on
the air conditioner. As the temperature falls below 60°C
(140°F), the disc will start playing again.
NO NAME:
Attempted to display DNPS during the CD play having no disc
names preset.
E51
LOAD:
Discs are being exchanged in the Disc changer.
E57-1
READING:
The unit is reading the data on the disc.
E57-2
NO ACCES:
After setting it in the Disc Changer, DNPP was done without
having it been played at least 1 time.
E58
IN (Blink):
The CD player section is not operating properly.
E59
➪ Reinsert the CD. If the CD cannot be ejected or the display
continues to flash even when the CD has been properly
reinserted, please switch off the power and consult your
nearest service center.
UNSUPPRT:
A MP3/WMA is played with a format that this unit can't
support.
E63
➪ ----
PROTECT:
A copy-protected file is played.
E64
➪ ----
This is the privileged Microsoft® Windows Media Audio
file.
➪ ----
KDC-MP225/225/2025_U.S 03.11.14 5:18 PM Page 31