Kenwood KDC-MPV622H3 - Manual (Page 11)

Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2 Enter Speaker Setting mode
Press the [System Q] button.
3 Select the Speaker type
Press the [
4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
Speaker type Display
OFF " SP OFF"
For 5 & 4 in. speaker "SP 5/4Inch"
For 6 & 6x9 in. speaker "SP 6*9/6Inch"
For the OEM speaker "SP O.E.M."
4 Exit Speaker Setting mode
Press the [System Q] button.
Speaker Setting
— 11 —
Turning the Non-fading (Sub woofer) output ON or OFF.
Press the [NF] button for at least 1 second.
Each time the button is pressed Non-fading (Sub woofer) output
switches ON or OFF.
When it’s ON, "NF ON" is displayed.
When the (page 25) is "SWPRE Rear", this
function is not available.
Non-fading (Sub woofer) Output
KDC-MPV622H3_U.S 03.7.1 2:20 PM Page 11