beautypg.com

Using and replacing the oven lights, Aring for your electric convection oven – KITCHENAID KEMC378 User Manual

Page 33

background image

2. Insert small end of a door removal pin

into each door hinge.

3. Grasp under handle and gently close

door as far as it will shut. Pull door out
at bottom to remove.

4. Set door aside on protected surface.

To replace:

1. Fit hinge arms into slots in frame. Push in

at lower corners to insure that hinge arms
are fully engaged.

33

C

aring for Your Electric Convection Oven

Using and replacing
the oven lights

The oven lights will come on when you open
the oven door. To turn the lights on when the
oven door is closed, press OVEN LIGHT
on the control panel. Press again to
turn off the lights.

NOTES:

Make sure the oven is cool before
replacing the light bulb.

The oven lights will not work during the
Self-Cleaning cycle.

Replacing the oven light:

1. Unplug oven or disconnect power.

2. Remove glass light cover by grasping the

front edge of cover and pulling it away
from the side wall of the oven.

3. Remove the light bulb from its socket.

Replace the bulb with another halogen
bulb (12 volt, 5 watt maximum, available
at most hardware stores).

4. Replace the light cover by snapping it

back into wall.

5. Plug in oven or reconnect power.

OVEN
LIGHT

OVEN
LIGHT

Insert small end

of pin here

2. Open the door all the way.
3. Remove the door removal pins from

each hole.

4. Close the door.

NOTE: If the door does not operate freely,
you have not installed it properly. Repeat
Steps 1 to 4.

4452300Bv09c40 1/21/00 4:37 PM Page 33

This manual is related to the following products: