KTI Networks KCD-302 Series - Manual (Page 27)

-27-
3.1.3 FX Port Duplex Settings SW5 SW6
This settings are used to set the duplex mode of the FX1 port and FX2
port individually. It is recommended to use full duplex mode for FX con-
nection unless its link partner is a fixed half duplex device. Half duplex
mode will shorten the connection distance. The following table lists the
maximum MMF cable length connecting to different devices:
Link Partner of FX Port Distance (MMF cable)
Network card half-duplex fiber port 400 m
Network card full-duplex fiber port 2 km
Class I hub half-duplex fiber port 160 m
2 Class II hub half-duplex fiber port 112 m
Switched half-duplex fiber port 400 m
Switched half-duplex fiber port 2 km
Note: For SMF connection, be sure the link partner is a full duplex
device and set SW5 SW6 to full duplex mode for the FX ports.
3.1.4 Factory Default Settings
The factory default settings are as follows:
SW1 OFF TP port mode - auto-negotiation
SW2 OFF TP port - full duplex
SW3 OFF TP port - 100Mbps
SW4 OFF Enable IEEE 802.3x flow control function
SW5 OFF FX1 port - full duplex
SW6 OFF FX2 port - full duplex