KORG DIGITAL RECORDING STUDIO D16 - Manual (Page 4)

2
Tempo map creation (specification change)
When you create a tempo map in the [TEMPO/
RHYTHM] “TmpMap” tab page, you can now specify
the beginning and end measures of the tempo map,
making it easier to manage the tempo map by mea-
sures. An “Insert” button has also been added, making
it easier to edit a previously-created tempo map.
[STOP] + [FF] (specification change)
By holding down the [STOP] key and pressing the [FF]
key, you can easily select the end of the song.
In the middle of the song, you can hold down the
[STOP] key and press the [FF] key to move to the end of
the song. At the end of the song, you can hold down the
[STOP] key and press the [FF] key to move to the begin-
ning of the next song.
Rhythm level control (specification change)
The “Mute” button in the [TEMPO/RHYTHM]
“SetUp” tab page and the “RhythmLevel” button in the
[Solo] “Monitor” tab page have been deleted.
This lets you adjust the “Rhythm” level and on/off set-
ting in a single page, by using “Vol” in the [TEMPO]
“SetUp” tab page.
You can also use the “Rhythm” button in the [Solo]
“Monitor” tab page as a master and monitor on/off
switch for the rhythm sound.
Optimize track (change)
This has been changed so that unneeded sound is not
generated if a track, or specified region is blank. If the
next event is not far away, the track will be generated as
a single piece of sound data to avoid “DiskBusy” indi-
cations.
Insert effect routing (specification change)
In the [INSERT EFFECT] “InsAss” tab page when
“Assign” is set to “In,” the “SelectInput” (input) setting
is now disabled. This makes the input setting match the
setting of [Input] “Ch1-8” and “Ch 9-16,” making the
signal easier to manage.
Improved “locate” operation in the Track View display
You can move smoothly through time in the Track View
display by rapidly turning the [VALUE] knob.
• In the [SYSTEM] “Control” page, the symbol indicat-
ing that the foot switch is pressed has been changed
from * to
.
• Due to the addition of the [SYSTEM] “MMC” page,
the location of the [SYSTEM] “DiskUtil” page has
changed from P4 to P6.
Main changes from the D16