Kolcraft S77-T-R3 - Manual (Page 5)

5
How to Assemble Your Stroller
To Open Stroller
Remove any cardboard inserts or plastic
ties used to protect the product during
shipment.
Release the locking latch.
Unfold, making sure both side locks snap
into place.
2
3
2
1
To Assemble Rear Wheels
Remove and discard protective plastic
sleeve from ends of brake assembly with
rear axle. Place stroller on floor with seat
facing down.
Position brake assembly with rear axle as
shown, with brake levers pointing
towards stroller handle.
Push both sides of brake assembly onto
rear leg tubes at the same time until
spring loaded buttons click into place.
N NO OT TE E:: Make sure that spring loaded
buttons pop through.
C CA AU UT TIIO ON N:: If spring loaded buttons DO
NOT pop through, front wheel assembly
could fall off during use.
Slide a rear wheel onto the axle then
slide a washer onto the axle.
Fit straight part of cotter pin through
hole on axle as shown.
Line up each of the tabs in the hub cap
with the slots in the wheel, snap hub cap
into place.
Repeat for second side.
2
3
1
4
5
6
7
2
4
5