Kenwood KDC-3023R - Manual (Page 25)

— 25 —
? The disc won’t insert. 65
✔ There’s already another disc inserted.
☞ Press the [0] button and remove the disc.
? Track Search can't be done. 66-2
✔ For the albums first or last song.
☞ For each album, Track Search can't be done in the backward
direction for the first song or in the forward direction for the last
song.
If the following situations, consult your nearest service
center:
• Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89, KDC-CPS87,
KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is
connected, the Auxiliary input is entered when switching modes.
The messages shown below display your systems
condition.
EJECT: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
E01
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
NO DISC: No disc has been loaded in the disc magazine. E02
➪ Load a disc into the disc magazine.
E-04: No disc has been loaded in the disc magazine. E04
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
➪ Clean the CD and load it correctly.
BLANK: Nothing has been recorded on the MD. E10
NO TRACK: No tracks are recorded on the MD, although it has a
title.
E11
NO PANEL: The faceplate of the slave unit being connected to
this unit has been removed. E30
➪ Replace it.
E-77: The unit is malfunctioning for some reason. E77
➪ Press the reset button on the unit. If the "E- 77"
code does not disappear, consult your nearest
service center.
E-99: Something is wrong with the disc magazine. Or the
unit is malfunctioning for some reason.
E99
➪ Check the disc magazine. And then press the reset
button on the unit. If the "E-99" code does not
disappear, consult your nearest service center.
HOLD: The protective circuit in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (140°F), stopping all operation.
E0d
➪ Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (140°F), the disc will start playing
again.
NO NAME: Attempted to display DNPS during the CD play having
no disc names preset.
E51
NO TITLE: Attempted to display the disc title or track title while
the MD having no MD title is being played.
E53
NO TEXT: Attempted to display the disc text or track text while
the CD having no CD text is being played.
E54
LOAD: Discs are being exchanged in the Disc changer. E57
NO ACCES: After setting it in the Disc Changer, DNPP was done
without having it been played at least 1 time.
E58
(Function of remote)
IN (Blink): The CD player section is not operating properly. E59
➪ Reinsert the CD. If the CD cannot be ejected or the
display continues to flash even when the CD has
been properly reinserted, please switch off the
power and consult your nearest service center.
KDC-3023R_U.S 02.9.26 3:14 PM Page 25