Kenwood KDC-3023R - Manual (Page 16)

Setting during operation beep sound etc. functions.
The Menu system basic operation method is explained here. The
reference for the Menu items and their setting content is after
this operation explanation.
1 Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.
2 Select the menu item
Press the [FM] or [AM] button.
Example: When you want to set the beep sound select the
"BEEP" display.
3 Set the menu item
Press the [
4] or [¢] button.
Example: When "BEEP" is selected, each time the button is
pressed it switches "BEEP ON" or "BEEP OFF". Select 1
of them as the setting.
You can continue by returning to step 2 and setting other items.
4 Exit Menu mode
Press the [MENU] button.
When other items that are applicable to the basic operation method
above are displayed afterwards their setting content chart is
entered. (Normally the uppermost setting in the chart is the original
setting.)
Also, the explanation for items that aren't applicable (Adjustment>etc.) are entered step by step.
Menu System
Menu system
— 16 —
English
Setting the operation check sound (beep sound) ON/OFF.
Display Setting
"BEEP ON" Beep is heard.
Touch Sensor Tone
"BEEP OFF" Beep canceled.
Synchronizing the RDS station time data and this unit's clock.
Display Setting
"SYNC ON" Synchronizes the time.
"SYNC OFF" Adjust the time manually.
It takes 3 to 4 minutes to synchronize the clock.
Synchronize Clock
This adjustment can be done when the (page
16) is set as OFF.
1 Select Clock Adjustment mode
Press the [FM] or [AM] button.
Select the "CLK ADJ" display.
2 Enter Clock Adjust mode
Press the [
4] or [¢] button for at least 2 seconds.
The clock display blinks.
3 Adjust the hours
Press the [FM] or [AM] button.
Adjust the minutes
Press the [
4] or [¢] button.
4 Exit Clock adjustment mode
Press the [MENU] button.
Manual Clock Adjustment
A red indicator will blink on the unit after the faceplate is
DSI (Disabled System Indicator)
KDC-3023R_U.S 02.9.26 3:14 PM Page 16