Kustom GROOVE 600TM - Manual (Page 9)

-12 dB
NORM -12dB
-6dB FLAT FLAT FLAT
+12dB
+6dB
-12dB
-6dB
+12dB
+6dB
-12dB
-6dB
+12dB
+6dB
9-BAND ACTIVE EQ
-12 dB
NORM -12dB
-6dB
FLAT FLAT FLAT
+12dB
+6dB
-12dB
-6dB
+12dB
+6dB
-12dB
-6dB
+12dB
+6dB
9-BAND ACTIVE EQ
9
GROOVE 600™
Specifications
The GROOVE 600™ was designed to mount into a standard 2-space rack. When mounting, use 4 screws to
secure the amplifier to the rack. When using only one amplifier, use the bottom 2 spaces in the rack.
However, if more than one amplifier is used, leave one space open between the amplifiers to ensure proper
ventilation (shown below).
Rack Mounting Instructions
Model Groove 600HD Bass guitar amplifier
Input Impedance
Output Power 275 Watts 8 Ohms @ 1% THD
450 Watts 4 Ohms @ 1% THD
600 Watts 2 Ohms @ 1% THD
Hum & Noise -60dB Residual Noise, all level controls 0% (minimum)
27dB Preamp output
15dB Preamp output, Gain switch set to -12dB
25dB Tuner output
27dB Direct output
29dB Power amp gain
Amplifier Type Class B Descrete device Class B amplifier
USA/Canada 120VAC/60Hz, 800W nominal
Europe 230VAC/50Hz, 800W nominal
UK 230VAC/50Hz, 800W nominal
Australia 240VAC/50Hz, 800W nominal
Japan 100VAC/50-60Hz, 800W nominal
mm/kg 89 (Height) x 483 (Width) x 390 (Depth), 12 kg
Inches/Pounds 3.5 (Height) x 19 (Width) x 15.5 (Depth), 26 lbs
200K Ohm
Use any standard tip-ring-sleeve 1/4" cable
KAC-GFS100 recommended, but any non-momentary two-button foot switch can be used.
Frequency Response 20HZ-20kHz
Actual response is tailored to speakers for accurate acoustical
response using a bass guitar as input.
Dimensions
Power Requirements
Footswitch
System Gain
All measurements taken with 1 KHz
input signal, Tone controls flat, Gain and
Volume Maximum. Measured at effects
send output jacks on rear unless noted.