Kustom GROOVE 600TM - Manual (Page 6)

Front Panel
a
Input Jack:
h
Bass Control:
T Controls the amount of low frequency in the signal.
This control is centered at 65 Hz.
i
Mid Control:
Controls the amount of midrange frequency in the
signal. This control is centered at 500 Hz.
j
High Control:
Controls the amount of high frequency in the signal.
This control is centered at 3 kHz.
c
Gain Control:
k
Graphic Equalizer Section:
Controls the amount of input to the preamp .
Adjust so SIG indicator illuminates when notes It may also be used to
are played finely adjust sound to taste.
d
Clip Indicator:
l
Master Volume Control:
Indicates when the input signal has reached Controls the overall output of the amplifier. Use in
maximum level. If indicator illuminates when conjunction with the GAIN control to obtain
notes are played , set switch to desired speaker output.
-12 dB and/or turn down GAIN control. m
Power Switch:
e
Signal Indicator: Turns AC power on and off. Note: When power is
Indicates when sufficient signal is applied to the first applied, there is a slight delay before sound is
preamp. Adjust GAIN control so indicator heard through the speakers.
illuminates when notes are played n
Solo Indicator:
f
Mute Indicator: This blue LED is lit when the SOLO mode has
This red LED will blink indicating all outputs are been activated.
muted except for the TUNER OUT (rear panel o
Solo On/Off Switch: T his switch when
#23). Muting can be done by either depressing the
depressed, activates SOLO mode. When active, the
MUTE ON/OFF switch on the front panel or by
signal to the power amp will be boosted by 6dB.
pressing MUTE on the footswitch. p
Power Jewel:
g
Mute On/Off Switch:
Indicates when AC power is applied to the
When t his switch is depressed, all outputs are
amplifier.
muted except for the TUNER OUT (rear panel
#23). Note: Using footswitch overrides this
switch.
his is a 1/4" 2-conductor input jack for plugging
in your instrument using a shielded instrument
cable. It is intended for bass guitar but will accept
other instruments and line level signals as well.
b
NORM/-12 dB Switch
Set this switch to -12 dB when using an active
bass guitar or line level signal. Setting to -12 dB
will lower the input gain by 12 dB.
This 9-band graphic equalizer is used to adjust the
sound to the room acoustics.
.
NORM/-12 dB
.
6
-12dB
-6dB
FLAT FLAT FLAT
+12dB
+6dB
-12dB
-6dB
+12dB
+6dB
-12dB
-6dB
+12dB
+6dB
9-BAND ACTIVE EQ