Troubleshooting guide, General, Tuner source – Kenwood DPX308U User Manual
Page 38: Disc source, Audio file source
38
|
DPX308U
Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up the low pass filter.
• No output from the subwoofer.
▲
•
“SUBWOOFER SET”
of
is
not set to On.
•
“LPF SUBWOOFER”
of
is
set to “THROUGH”.
• Preout is not set to subwoofer.
“SWITCH PREOUT”
of
.
!
Cannot set up Display.
▲
is not
turned off.
!
The number of songs contained in “SONGS”
category of this unit is different from that
contained in “SONGS” category of iPod.
▲
Podcast files are not counted in this unit as this unit
does not support the playback of podcast files.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The operation check sound (beep sound) does not
sound.
The preout jack is being used.
The Touch Sensor Tone cannot be output from
the preout jack.
Tuner source
?
Radio reception is poor.
The car antenna is not extended.
Connect the Antenna control wire to the power
terminal for the booster amplifier of the film-type
or short pole type antenna
Pull the antenna out all the way.
Disc source
?
The specified disc does not play, but another one
plays instead.
The specified CD is quite dirty.
Clean the CD, referring to the CD cleaning of the
section on
.
The disc is severely scratched.
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD cleaning of
the section on
.
The recording condition is bad.
Record the media again or use another media.