Troubleshooting guide – Kenwood KDC-PSW9521 EN User Manual
Page 45
— 45 —
— 45 —
Troubleshooting Guide
?
Non-fading output, Non-fading Low Pass Filter and Non-fading
setting can’t be done.
28
✔ The
29
☞ Turn it ON.
✔ The
30
☞ Turn it OFF.
?
There’s no Front High Pass Filter and Rear High Pass Filter effect.
31
✔ The Non-fading preout is being used.
☞ There’s no effect in Non-fading preout.
?
The Mask Key item isn’t displayed in the Menu System.
33
✔ The Mask Key function is already activated.
☞ When the Mask Key function is activated it isn’t displayed in the
menu items.
?
The Touch Sensor Tone doesn’t sound.
34
✔ The preout jack is being used.
☞ The Touch Sensor Tone can’t be output from the preout jack.
?
Even though Synchronize Clock is ON, the clock can’t be adjusted.
35
✔ The received RDS station isn’t sending time data.
☞ Receive another RDS station.
Tuner source
?
Radio reception is poor.
39
✔ The car antenna is not extended.
☞ Pull the antenna out all the way.
✔ The antenna control wire is not connected.
40
☞ Connect the wire correctly, referring to the section on
?
The desired frequency can’t be entered with the Direct Access
Tuning.
41
✔ A station that can’t be received is being entered.
☞ Enter a station that can be received.
✔ You’re trying to enter a frequency with a 0.01 MHz unit.
42
☞ What can be designated in the FM band is to 0.1 MHz.
Disc source
?
"AUX" is displayed without achieving External disc control mode.
50
✔ O-N switch is set to "O" side.
☞ Set the switch to "N" side.
✔ Unsupported disc changer is connected.
51
☞ Connect the supported disc changer. (page 3)
?
The specified disc does not play, but another one plays instead.
52
✔ The specified CD is quite dirty.
☞ Clean the CD.
✔ The CD is upside-down.
53
☞ Load the CD with the labeled side up.
✔ The disc is loaded in a different slot from that specified.
54
☞ Eject the disc magazine and check the number for the specified
disc.
✔ The disc is severely scratched.
55
☞ Try another disc instead.
?
The specified track will not play.
58
✔ Random play or magazine random play has been selected.
☞ Turn off random play or magazine random play.
?
Track repeat, disc repeat, track scan, random play, and magazine
random play start by themselves.
59
✔ The setting is not canceled.
☞ The settings for these functions remain on until the setting to off
or the disc ejected, even if the power is turned off or the source
changed.
?
The specified track will not play.
58-a
✔ Random play has been selected.
☞ Turn off random play.
?
Cannot play CD-R or CD-RW.
60
✔ Finalization processing is not being conducted for CD-R/CD-RW.
☞ Conduct finalization processing with CD recorder.
✔ A non-compatible CD changer is being used to play the CD-R/CD-
RW.
61
☞ Use a CD changer compatible with CD-R/CD-RW to play.
KDC-M907
_U.S 04.2.4 4:17 PM Page 45