Kenwood KDC-PSW9521 EN - Manual (Page 11)

Press the [ANG] button for at least 1 second.
Do not apply excessive force to the faceplate. It can cause damage.
Faceplate Angle Adjustment
Function of the KDC-PSW9521/KDC-M907/KDC-M9021
Turning the Non-fading output ON or OFF.
Press the [NF] button for at least 1 second.
Each time the button is pressed Non-fading output switches ON
or OFF.
When it’s ON, "NF ON" is displayed.
Non-fading Output
Adjustment Item Display Range
Bass Center Frequency "Bass FRQ" 60/70/80/100 or 150 Hz
Bass level "Bass" –8 — +8
Bass Q Factor "Bass Q" 1.00/1.25/1.50/2.00
Bass Extend "Bass EXT" ON/OFF
Middle Center "MID FRQ" 0.5/1.0/1.5/2.0 kHz
Frequency
Middle level
"MID" –8 — +8
Middle Q Factor "Middle Q" 1.0/2.0
Treble Center Frequency"TRE FRQ" 10.0/12.5/15.0/17.5 kHz
Treble level "TRE" –8 — +8
Balance "Balance" Left 15 — Right 15
Fader "Fader" Rear 15 — Front 15
Non-Fading level* "NF Level" –15 — +15
Front High Pass Filter* "HPF Front" Through/40/60/80/100/
120/150/180/220 Hz
Rear High Pass Filter* "HPF Rear" Through/40/60/80/100/
120/150/180/220 Hz
Non-Fading "LPF NF" 50/80/120/Through Hz
Low Pass Filter*
Non-Fading Phase*
"NF Phase" Normal (0°)/Reverse
(180°)
Volume offset "Volume Offset" –8 — ±0
Loudness "LOUD" ON/OFF
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the bass extend is set to ON, low frequency response is
extended by 20%.
• Volume offset: Each source's volume can be set as a difference
from the basic volume.
— 11 —
• Loudness: Compensating for low and high tones during low
volume.
(KDC-PSW9521) The graphic is displayed when
Loudness is ON, and is switched OFF when Loudness
is OFF.
• * :Function of the KDC-PSW9521/ KDC-M907/ KDC-M9021
5 Exit Audio Control mode
Press the [AUD] button.
KDC-M907 _U.S 04.2.4 4:17 PM Page 11