Konica Minolta NC-6 - Manual (Page 34)

Connecting the Computer and Copier 7
NC-6 7-7
7 Enter the IP address for the copier into the Printer Name or IP
Address box, and then click [Next>].
8 Select Custom , and then click [Settings].
9 Select RAW as the protocol.
10 Enter “9100” for the Port Number setting, and then click [OK].
11 Click [Next>].
12 Click [Finish].
7.2.4 IPP Printing
Windows 2000/ Windows XP
✎
Important
Before continuing to set up the network settings, check the following:
Check that the computer is set up to use the TCP/IP protocol.
Check that the copier is also set up to use the TCP/IP protocol.
Check the IPP Settings Using PageScope Light
Use PageScope Light to access the copier and check if IPP printing is
enabled. For instructions on using PageScope Light, refer to “8 Using
PageScope Light”.
1 Start up PageScope Light.
2 Log in to the Administrator mode.
3 Click the “Network” tab, and then select “IPP Configuration” in the
menu.
4 Check that Enable IPP is selected. If it is not selected, IPP printing is
not possible.