Keys Fitness ST-2600 - Manual (Page 8)

ASSEMBLY INSTRUCTIONS
STEP #3
e.
C)
arm curl handle
be
E)
washers 8 (#B2). Push the arm curl post down into the top of the front base, adjust and
secure with one small knot bolt M12x60mm (#31) installed from behind the front base.
A) Attach the leg developer (#37) between the brackets on the front of the front base with one
bolt M10X75 (#A3), two washers 10 (#B1) and a nylon M10(#C1) nut.
B) Push a roller tube (#34) through the upper and lower holes in the leg developer and through
the tube welded to the back of the front base. Push a foam roll onto each side of each tub
Attach the arm curl handle (#39) between the brackets on the top front of the leg developer
with the ring head lock pin (#38). The attached arm curl pad (#27) on the
should face down. If you are using Olympic weights, slide the Olympic adapter (#35) onto
the leg developer weight holder and secure with the spring collar (#36).
D) Push the threaded end of the leg developer safety hook (#33) through the small welded tu
across the front of the front base secure with one small nylon nut M8 (#C2).
Attach the arm curl pad to the arm curl post (#28) with two bolts M8x20 (#A6) and two