Keys Fitness ST-2600 - Manual (Page 6)

ASSEMBLY INSTRUCTIONS
Before beginning the assembly process take a few moments to familiarize yourself with the
specific parts and hardware. Make sure all the parts are included in the carton and examine them
for any damage that may have occurred in transport. During assembly it is only necessary to
tighten the nuts and bolts to finger tight. This will make it easier to complete certain steps during
cess. Do not tighten the bolts and nuts completely until instructed to do so in step
STEP #1
B) ith two bolts M10x90
D) top
mm (#3) down
nylon nut M8 (#C2)
)
of the backrest adjustm
the assembly pro
#3
A) Place the left (#5) and right (#11) uprights on the floor as illustrated. The brackets welded
down the side of each upright should be to the inside and facing each other.
Attach each end of the cross bar (#10) to the front of each upright w
(#A2), four washers 10 (#B1) and two nylon nuts M10 (#C1). Install a rectangular
reinforcement plate (#8) behind each upright during this assembly.
C) Push a weight storage tube (#7) into the hole in the angled brace behind each upright and
secure from below with one bolt M8x20 (#A6) and one washer 8 (#B2).
Push each crutch (#2) down into the top of each upright so that the longer bar catch at the
of each crutch is to the rear of the bench. Push the rect. out plug 50x70
around the top of each upright. Secure and adjust each crutch inside each upright using a
long knob bolt M12x80mm (#4) installed from the rear of each upright.
E) Push the threaded end of each safety hook (#1+) through the small welded tube at the top
rear of each crutch as illustrated. Secure each safety hook with one
F Place the backrest adjustment bar (#12) between the uprights so that the short pin at each end
ent bar is seated into the hole in a bracket.