Kenwood KAC-PS810D - Manual (Page 7)

English
7
Connection
REVERSE NORMAL
PHASE BAND REJECT
–12dB –6dB OFF
B.M.S.
+12dB OFF REMOTE
INFRASONIC
25Hz 15Hz ON OFF
GND
LINE OUT EXT.AMP.CONT. LINE IN
L
R
L
R
25 25 25
SPEAKER
OUTPUT
POWER IN
P.CON BATT. GND
FUSE(25Ax3)
^ ( & *
! @ # $ %
! Fuse (25 A × 3)
@ Battery terminal
# Ground terminal
% Speaker output terminals
As this unit accepts speakers with a
minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance
to these terminals.
The rated input of the speakers should be
no less than the maximum output of the
amplifier. Otherwise malfunction may
result.
^ RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
& LINE IN terminal
* LINE OUT terminal
The signal that’s input from the line input
terminal is output.
$ Power control terminal
Controls the unit ON/OFF.
Controls the unit power. Be sure to connect it
with all the systems.
( EXT.AMP.CONT. (external
amplifier control) terminal
Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
There are cases when operation may not be
possible due to wiring wire type and length.
NOTE
NOTE
2CAUTION
■ Terminal names