Assigning trunks and setting vlan groups – Kingston Technology Kingston Fast EtheRx KNS3250/R User Manual
Page 32
KNS3250/R Users Guide - Rev. A00
Kingston Technology Company
Kingston Switch Configuration Utility
27
Assigning Trunks and Setting VLAN Groups
Fast EtheRx 10/100TX
24-Port VLAN/Trunking Switch
KNS2450/R
LINK / ACT
FDX / COL
POWER
LINK / ACT
FDX / COL
2/FX2 4
6
8
10
12
14
16
18
20
22
24
1/FX1 3
5
7
9
11
13
15
17
19
21
23
2/FX2
4
6
8
9
11
13
15
10
12
14
16
17
19
21
23
18
20
22
24
1/FX1
3
5
7
100 Mbps
10 Mbps
FDX
COL
FX Module
Fig. 4 - VLAN example
Here we give an example to show how to assign trunks and set VLAN groups.
From the gure above, the user plans to congure a 24 port switch into two VLAN
groups, one for Engineering and the other for Sales/Marketing. There are four
stations connected to Port 5 to Port 8 respectively used by engineers, and a server
shared by them which is connected to Trunk 1 by using four trunk ports. On the
other side, there are three stations connected to Port 9 to Port 11 respectively used
by Sales/Marketing department, and a server shared by them which is connected to
Trunk 6 by using two trunk ports.
To achieve the goal above, just follow steps below:
1. Click the Properties button to open the Properties window.
VLAN #1:
Engineering
VLAN #2:
Sales/Marketing