KORG KEY MUSIC WORKSTATION N364 - 61 - Manual (Page 6)

Bank Change Messages For Korg Products
Most sequencers have an event edit mode, which allows inputting controller messages. Bank change
messages require these events: Beat one, tick one: Controller 0 with its value - Beat one, tick two:
Controller 32 with its value - Beat one, tick three: Program change. Make sure that Program Change
and Exclusive filters are set to enable (ENA) to receive these commands. Note: These listing covers all
possible bank changes in the product lines specified for each chart. Since some models don't have all of
the mentioned banks, some messages will not be received.
X Series/N364/264/Trinity Series/ Z1/Z1EX
BANK A
Message Value
Controller 0
0
Controller 32 0
Program Change 0-99 (0-127)
BANK B
Message Value
Controller 0
0
Controller 32 1
Program Change 0-99 (0-127)
BANK C
Message Value
Controller 0
0
Controller 32 2
Program Change 0-99 (0-127)
BANK D
Message Value
Controller 0
0
Controller 32 3
Program Change 0-99 (0-127)
BANK S/M (Trinity)
Message Value
Controller 0
0
Controller 32 4
Program Change 0-99 (0-127)
GM BANK (X and N Series)
Message Value
Controller 0
56
Controller 32 0
Program Change 1-128
GM DRUM BANK (X and N Series)
Message Value
Controller 0
62
Controller 32 0
Program Change *
Triton Classic/Studio/Extreme/Rack/Le/Karma
BANK INT-A
Message Value
Bank Map (GM) (Korg)
Controller 0 63 0
Controller 32 0 0
Program Change 0-127 0-127
BANK INT-B
Message Value
Bank Map (GM) (Korg)
Controller 0 63 0
Controller 32 1 1
Program Change 0-127 0-127
BANK INT-C
Message Value
Bank Map (GM) (Korg)
Controller 0 63 0
Controller 32 2 2
Program Change 0-127 0-127
BANK INT-D
Message Value
Bank Map (GM) (Korg)
Controller 0 63 0
Controller 32 3 3
Program Change 0-127 0-127
BANK INT-E
Message Value
Bank Map (GM) (Korg)
Controller 0 63 0
Controller 32 4 4
Program Change 0-127 0-127
BANK INT-F
Message Value
Bank Map (GM) (Korg)
Controller 0 63 0
Controller 32 5 5
Program Change 0-127 0-127