General features, G-analyzer display switching – Kenwood KDC-MP732 User Manual
Page 22
22
|
English
General features
Display Type E
G-Analyzer display Switching
Alternates G-Analyzer display when the Display
type is set to "Display Type E". (G: gravity)
• Before alternating G-Analyzer display, you are
required to setup
1
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [2] button.
Refer to
(page 9).
2
Enter display control mode
Press the [2] ("DISP") button.
3
Select the display mode
Press the [1] ("MODE") button.
Select the "Display Type E" display.
4
Enter G-Analyzer display select mode
Press the [3] ("GMENU") button.
5
Select the G-Analyzer display
Push the Control knob towards [
4] or
[
¢].
G-Force Sensor display
G- Graphic display*
G-Meter display
(Graphic)
G-Meter display
(Text)
Point
Time
G-Counter display
• G-Graphic display
Displays the condition of G in horizontal direction
(e.g; when turning the curve) by the graphic.
• * G-Graphic can be switched to customized pictures.
Refer to
• G-Meter display (Graphic)
Displays the maximum value of acceleration G, right
direction G, and left direction G by the numerical
value.
• G-Meter display (Text)
The maximum value of acceleration G, right direction
G, and left direction G is displayed by the numerical
value. The value of G is only the reference, so is
different from the actual value.
• G-Counter display
Adds the point of the acceleration level. The point is
determined after a lapse of 1 hr drive or at power off
(ACC Off ), and then it will be displayed by the graph.
Furthermore, the G-Counter displays the average
of the past data by the line. (The scale of graph is
determined along with the largest point among the
past 10 data.)
• The value of G-Meter display and G-Counter display
can be reset by
6
Exit display control mode
Press the [6] ("RTN") button.