Displaying the speaker set up screen, Displaying the channel level screen, English 47 – Kenwood DDX7045 User Manual
Page 47: Unit
English 47
Displaying the Speaker Set Up
screen
When the speaker type and size are set, the speaker
crossover network and equalizer curve are set
automatically.
Speaker Set Up screen
Displaying the Channel Level
screen
You can set the volume at each setup position.
Channel Level screen
7 Displays the X'over (HPF) screen.
(See
8 Display the X'over (LPF) screen.
(See
9 Sets up the front speaker type to fine-tune for the
optimal equalizer curves.
Standard: Setup for general diameter speakers
Narrow:
Setup for small diameter speakers
Middle:
Setup for small diameter woofer
Wide:
Setup for large diameter woofer
p Select the speakers for Multi-channel sounds.
"3/2": Center speaker, Front speaker, Rear speaker
"2/2": Front speaker, Rear speaker
"3/0": Center speaker, Front speaker
"2/0": Front speaker
q Set the use or no use of Sub Woofer.
w Displays the Channel Level Setup screen.
e Displays the Car Type Set Up screen.
• "X’Over HPF" and "X’Over LPF" can be set only
when "Sub Woofer" is set to "On".
• "Multi Channel" can be set only when "Dolby Pro
Logic" (see page 75) is set to "On".
r Selects a speaker to be set.
(see
t Sets the speaker volume.
(see
y Starts or stops test signal tone output for setup
check.
u Displays the Speaker Set Up screen.
• Your setup on the
adjusted automatically to get the best sound
effects according to the car type and speaker you
have set on the
• Stop the test signal tone if you have finished
setting up the Channel Level. If you leave the test
signal tone on, you may not be able to set up
other settings.
unit.
+ 1 0 dB
Ce n t e r
M e n u
C h a n n e l L e v e l
T e s t
Set Up
SRC
Audio
X ' Ov e r HPF
X ' Ov e r LPF
S u b Woo f e r
O f f
S t a n d a r d
F r o n t L &R
3 / 2
M u l t i C h a n n e l
M e n u
Sp e a k e r
Set Up
SRC
Audio
9
9
11
10
10
12
13
14
15
15
16
17
7
8
DDX7035/7045/7065_M(En)v2.6 04.4.18 8:49 PM ページ47