Konica Minolta Pi2001e - Manual (Page 20)

Installing the Printer Driver 4
Pi1803e/Pi2001e 4-1
4 Installing the Printer Driver
This section describes the procedure for installing the printer driver. The
printer driver can be installed in two ways: by using Plug and Play or by
using the Add Printer Wizard.
For network printing, use the Add Printer Wizard to install the printer
driver. During installation, select “LPT1” as the printer port.
For details on specifying network connection settings, refer to the User
Manual for the network interface card.
✎
Note
In order to use IPP printing, the IPP printing settings must be specified
when the printer driver is installed. For details on specifying the IPP
printing settings, refer to the manual provided with the network
interface card.
If the PCL printer controller is used on Windows 95, Windows 98,
Windows 98SE or Windows Me, the Network Setup utility cannot be
used.
If you want to use
this function to
install the printer
driver: Follow this procedure:
Plug and Play
(for USB connection) “Installing the Printer Driver Using Plug and Play”
on page 4-2
Add Printer Wizard
(for parallel
connection) “Installing the Printer Driver Using the Add
Printer Wizard” on page 4-5