Connecting wires to terminals – Kenwood KDC-MP3035 User Manual
Page 27
English
|
27
Connecting Wires to Terminals
P.CONT
ANT CONT
MUTE
FRONT L
FRONT R
REAR L
REAR R
–
+
FRONT
REAR
FM/AM antenna input
Front left output (White)
Front right output (Red)
Fuse (10A)
Wiring harness
(Accessory
1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left speaker
To front right speaker
To rear right speaker
To rear left speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black)
- (To car chassis)
Ignition key
switch
Car fuse box
(Main fuse)
ACC
Car fuse
box
Battery
If no connections are made, do not let the wire come out from the tab.
Power control wire (Blue/White)
Motor antenna control wire (Blue)
When using the optional power amplifier, connect to its power
control terminal.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal
for the booster amplifier of the film-type antenna.
Sub Woofer left output (White) (KDC-MP3035)
Sub Woofer right output (Red) (KDC-MP3035)
To connect the Kenwood navigation system, consult your
navigation manual.
TEL mute wire (Brown)
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect these leads, refer to the relevant
instruction manuals.
To Kenwood disc changer/
External optional accessory
Rear left output (White) (KDC-MP3035)
Rear right output (Red) (KDC-MP3035)
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
Rear left output/Sub Woofer left output (White) (KDC-MP335)
Rear right output/Sub Woofer right output (Red) (KDC-MP335)