Menu system – Kenwood KDC-MP3035 User Manual
Page 20
20
|
English
Menu system
In Standby mode
Manual Clock Adjustment
1
Select Clock Adjustment mode
Push the Control knob towards [FM] or [AM].
Select the "CLK ADJ" display.
2
Enter Clock Adjust mode
Press the Control knob for at least 1 second.
The clock display blinks.
3
Adjust the hours
Push the Control knob towards [FM] or [AM].
Adjust the minutes
Push the Control knob towards [
4] or [¢].
4
Exit Clock adjustment mode
Press the [MENU] button.
In Standby mode
DSI (Disabled System Indicator)
A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display
Setting
"DSI ON"
LED flashes.
"DSI OFF"
LED OFF.
Display Illumination Control
This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display
Setting
"DISP ON"
Keeps the display on.
"DISP OFF"
Turns off the display when you perform no
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
Dimmer
You can lower the brightness of the display by using
the dimmer function.
Display
Setting
"DIM ON"
The display dims.
"DIM OFF"
The display doesn’t dim.
Function of KDC-MP335
In Standby mode
Switching preout
Alternating the preout between the rear and
subwoofer. (With the subwoofer the sound outputs
without being effected by fader control.)
Display
Setting
"SWPRE R"
Rear preout.
"SWPRE SW"
Subwoofer preout.
In Standby mode
Touch Sensor Tone
Setting the operation check sound (beep sound)
ON/OFF.
Display
Setting
"BEEP ON"
Beep is heard.
"BEEP OFF"
Beep canceled.