Attaching fabric brush to iron, Operating the ironing station – Kalorik USK SIT 25803 User Manual
Page 11
11
USK SIT 25803 - 080425
Figure 17
ATTACHING FABRIC BRUSH TO IRON
CAUTION: Use care when attaching fabric brush, as the sole plate
may be hot. Do not attempt to attach fabric brush while appliance is
emitting steam. As shown in figure 18 below, slide the fabric brush
over the sole plate until it clicks in place. When the fabric brush is
clipped in place you may begin steaming.
OPERATING THE IRONING STATION
1. NOTE: The very first time you use the ironing station, turn the steam
output dial to maximum, press and lock the regular steam button
and let the appliance run for 2 minutes on maximum. This is only
required the very first time you use the ironing station. For subsequent
use, it is not necessary to run the unit for 2 minutes, it can be used
immediately. For the first hour of use, the ironing station may not
perform at its optimum. This is due to the appliance needing time to
settle. After the first hour, performance will improve.