Karcher G 2000 MK User Manual

Page 7

English

CAUTION

Too much oil can cause the engine to over-
heat. Signs include but are not limited to the
following: a decrease in engine perfor-
mance, oil leaking from the governor arm,
an oil seal, or the air filter.
To correct this, immediately drain the oil
from the engine and make sure you are us-
ing the correct amount of oil as shown pre-
viously.
Î

STEP 2:
Before starting the engine, move the
CHOKE lever to the CHOKE position
as indicated.

After engine has warmed and idles
smoothly, move CHOKE lever to the
RUN position as indicated.

Warm engine starting:
Move the CHOKE lever to the CHOKE
position as indicated in the previous
step. Once you have achieved stable
idle, move CHOKE lever back to RUN
position.

STEP 3:
Connect the high pressure hose to the
unit’s high pressure outlet.

STEP 4:
Connect garden hose to unit’s water in-
let.

STEP 5:
Connect garden hose to the cold water
source and turn water on completely.
Do not use hot water.

STEP 6:
If the trigger gun safety lock is engaged,
please disengage.

Hold the trigger gun open until all
trapped air is eliminated from the low
pressure water stream.

STEP 7:
Check oil level.
Please see STEP1 for details on min/
max levels

STEP 8:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Do not mix oil into the gasoline.