Karcher G 2000 MK - Manual (Page 5)

English
5
ƽ
WARNING
„ Do not check for spark with the spark
plug removed.
„ Do not touch the high-voltage cord or
spark plug cap.
„ Do not stop the machine by using the
choke lever.
„ Do not unreasonably adjust the engine
speed.
„ Do not place hands or feet near moving
or rotating parts.
„ Do not operate machine with combusti-
ble material in the muffler area.
ƽ
CAUTION
„ Do not touch hot surfaces or allow ac-
cessories to contact hot surfaces.
„ The machine has hot surfaces which
can cause burns. Operate the unit in a
safe environment and away from chil-
dren.
„ Remove trash, grass and other debris
from around the cooling fins and recoil
starter.
„ Allways use new gasoline. Old gasoline
could cause build up in the carburetor
which could cause poor engine opera-
tion.
SAVE THESE INSTRUCTIONS
ƽ
CAUTION
When connecting the water inlet to the
water supply mains, local regulations of
your water company must be observed.
In some areas the unit must not be con-
nected directly to the public drinking wa-
ter supply. This is to ensure that there is
no feedback of chemicals into the water
supply. Direct connection via a receiver
tank or backflow preventer, for exam-
ple, is permitted.
Dirt in the feed water will damage the
unit. To avoid this risk, we recommend
fitting a water filter.
„ Garden hose must be at least 5/8 inch in
diameter.
„ Flow rate of water supply must not fall
below 2.8 GPM (gallons per minute).
„ Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
„ The water supply temperature must not
exceed 104°F/40°C.
„ Never use the pressure washer to draw
in water contaminated with solvents,
e.g. paint thinners, gasoline, oil, etc.
„ Always prevent debris from being
drawn into the unit by using a clean wa-
ter source. Use additional water filter.
„ Do not operate pressure washer without
the water turned on.
WATER SUPPLY
(Cold Water Only)