Kenwood TM-271 - Manual (Page 67)

61
11
3 Turn the Tuning control to select a character.
• You can enter the following alphanumeric characters:
0 ~ 9, A ~ Z, – (hyphen), / (slash), and a space.
• Rather than using the Tuning control, you can use the
Mic keypad (keypad models only) to enter alphanumeric
characters {page 64}.
4 Press [MR] to move to the next digit.
• To move to the previous digit, press [VFO]. To delete
the character at the current cursor position, press [F].
5 Repeat steps 3 and 4 to enter up to 6 digits.
6 Press [MENU] to complete the setting and store the
Power-on message.
7 Press any key other than [MENU] to exit Menu Mode.
Note: If a Power-on message is not set, the transceiver model name
appears when the transceiver power is turned ON.
PROGRAMMABLE VFO
To limit the operating frequencies within a certain range,
program the upper and lower frequency limits to the
program VFO parameters. For example, if you select
144 MHz for the lower limit and 145 MHz for the upper
limit, the tunable range will be limited from 144.000 MHz
to 145.9975 MHz.
1 While in VFO mode, press [F], [MENU] and turn the
Tuning control to select Menu No. 7 (P.VFO).
• The current programmable frequency range for the band
appears.
2 Press [MENU] and turn the Tuning control to select
the lower limit frequency (in MHz).
3 Press [MENU] and turn the Tuning control to select
the upper limit frequency (in MHz).
4 Press [MENU] to store the setting or any other key to
cancel.
5 Press any key other than [MENU] to exit Menu Mode.
Note:
◆ You cannot program the 100 kHz or lower digits.
◆ The upper limit frequency cannot be set lower than the selected
lower limit frequency.