Kenwood TM-271 - Manual (Page 66)

60
11
• SHIFT: Shift function ON/OFF
• LOW: Select transmission power
• BRIGHT: Adjust display backlight
• LOCK: Transceiver Lock function ON/OFF (must be held
down for 1 second to activate)
• TONE: Selection for Tone/ Selective Call
• STEP: Select the frequency step size
Note: Rather than entering Menu Mode and selecting PF1 ~ PF4,
you can simply press and hold the PF key you want to program, then
turn the transceiver power ON. When programming the PF keys in
this manner, select the function by turning the Tuning control or
pressing Mic [UP]/[DWN], press [MENU] to store the setting, then
press any key other than [MENU] to exit Menu Mode.
NARROW BAND FM OPERATION
By default, the transceiver operates in normal FM
(±5 kHz) mode for both transmission and reception. You
can also operate the transceiver in narrow band FM
(±2.5 kHz).
To operate the transceiver in narrow band FM:
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 26 (FMN).
2 Press [MENU] and turn the Tuning control to select
“ON” or “OFF” (default).
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
When narrow band FM operation is ON, “N” appears in
the top right of the LCD.
Note: You can store the narrow band FM operation status to the
Memory Channels {page 29}.
POWER-ON MESSAGE
You can change the Power-on message (a maximum of
6 characters) when the transceiver is turned ON.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 23 (P.ON.MSG).
2 Press [MENU].
• The current message and entry cursor appear.