Instructions for kodak i200 series scanners – Kodak I100 User Manual

Page 2

Instructions for Kodak i200 Series Scanners

1. Power down the scanner.
2. Access the inside of the scanner by opening the

scanner cover.

3. Lift up the scanner door release again and open the

scanner door past the circuit board cover.

Replacing the Upper Imaging Guide
1. Locate the upper imaging guide.
2. Clean the upper transport area and imaging guide.
3. Remove the screw from the upper imaging

guide bracket.

4. Slide the bracket away from the imaging guide.
5. Pull gently on the end of the imaging guide and slowly

remove it from the scanner.

6. Discard the used imaging guide.
7. Remove any dust or debris from the guide track. Do not

allow debris to fall into the scanner.

8. Wipe both sides of the new upper imaging guide with a

fresh Staticide Wipe.

9. Dry both sides of the new upper imaging guide with a

dry Staticide Wipe.

10. Align the new upper imaging guide in the guide track

and slowly push it in.

11. Slide the bracket until it rests against the end of the

imaging guide.

12. Re-install the screw in the upper imaging guide bracket.

Do not over-tighten.

Replacing the Lower Imaging Guide
1. Locate the lower imaging guide.
2. Clean the lower transport area and imaging guide.
3. Remove the screw from the lower imaging guide.

4. Pull gently on the end of the imaging guide and slowly

remove it from the scanner.

5. Discard the used imaging guide.
6. Remove any dust or debris from the guide track. Do not

allow debris to fall into the scanner.

7. Wipe both sides of the new lower imaging guide with a

fresh Staticide Wipe.

8. Dry both sides of the new lower imaging guide with a

dry Staticide Wipe.

9. Align the new lower imaging guide in the guide track

and slowly push it in.

10. Re-install the screw in the lower imaging guide. Do not

over-tighten.

11. Close the scanner door.

Lower imaging guide

Circuit board cover

Upper imaging guide

Screw

Bracket

Screw

Lower imaging guide