Kenwood KRC-597 - Manual (Page 33)

— 33 —
MECHA ER: Something is wrong with the disc magazine. Or the unit is
malfunctioning for some reason.
E99
➪ Check the disc magazine. And then press the reset button
on the unit. If the "MECHA ER" code does not disappear,
consult your nearest service center.
HOLD ER: The protective circuit in the unit activates when the
temperature inside the automatic disc changer exceeds 60°C
(140°F), stopping all operation.
E0d
➪ Cool down the unit by opening the windows or turning on
the air conditioner. As the temperature falls below 60°C
(140°F), the disc will start playing again.
NO NAME: Attempted to display DNPS during the CD play having no disc
names preset.
E51
WAITING: Radio text data is being received. E56
LOAD: Discs are being exchanged in the Disc changer. E57-1
IN (Blink): The tape player section is not operating properly. E60
➪ Reinsert the Tape. If the tape cannot be ejected or the
display continues to flash even when the tape has been
properly reinserted, please switch off the power and
consult your nearest service center.
The messages shown below display your systems
condition.
EJECT: No disc magazine has been loaded in the changer. The disc
magazine is not completely loaded.
E01
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
NO DISC: No disc has been loaded in the disc magazine. E02
➪ Load a disc into the disc magazine.
TOC ER: No disc has been loaded in the disc magazine. E04
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is
scratched a lot.
➪ Clean the CD and load it correctly.
E-05: The CD is upside-down. E05
➪ Load the CD correctly.
BLANK: Nothing has been recorded on the MD. E10
NO TRACK: No tracks are recorded on the MD, although it has a title. E11
E-15: Media was played that doesn’t have data recorded that the
unit can play.
E15
➪ Use media that has data recorded that the unit can play.
NO PANEL: The faceplate of the slave unit being connected to this unit
has been removed.
E30
➪ Replace it.
E-77: The unit is malfunctioning for some reason. E77
➪ Press the reset button on the unit. If the "E-77" code does
not disappear, consult your nearest service center.
KRC-597(E)_U.S 03.10.7 6:48 PM Page 33