Kenwood KRC-597 - Manual (Page 30)

English
— 30 —
Catch
Lock
Accessory2
Removal tool
— 30 —
■ Removing the hard rubber frame
2 When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1 Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
■ Removing the Unit
4 Lower the removal tool
toward the bottom, and
pull out the unit halfway
while pressing towards the
inside.
5 Pull the unit all the way out
with your hands, being
careful not to drop it.
Be careful to avoid injury from the catch pins on the removal tool.
1 Refer to the section and
then remove the hard rubber frame.
2 Remove the screw (M4 ×8) on the back panel.
3 Insert the two removal tools deeply into the slots on each
side, as shown.
Accessory2 Removal tool Screw (M4X8)
(commercially
available)
Installation
KRC-597(E)_U.S 03.10.7 6:48 PM Page 30