Troubleshooting guide – Kenwood KRC-597 User Manual
Page 32
— 32 —
English
Troubleshooting Guide
Disc source
?
"AUX1" is displayed without achieving External disc control mode.
50
✔ Unsupported disc changer is connected.
51
☞ Use the disc changer mentioned in the IMPORTANT
INFORMATION of the section on
?
The specified disc does not play, but another one plays instead.
52
✔ The specified CD is quite dirty.
☞ Clean the CD.
✔ The disc is loaded in a different slot from that specified.
54
☞ Eject the disc magazine and check the number for the specified
disc.
✔ The disc is severely scratched.
55
☞ Try another disc instead.
If the following situations, consult your nearest service
center:
Even though the disc changer is connected, the Disc Changer source is not
ON, with "AUX1" showing in the display during the Changer Mode.
Cassette tape source
?
Can’t remove tape.
44
✔ The cause is that more than 10 minutes has elapsed since the vehicle
ACC switch was turned OFF.
☞ The tape can only be removed within 10 minutes of the ACC
switch being turned OFF. If more than 10 minutes has elapsed,
turn the ACC switch ON again and press the Eject button.
?
The DPSS and Music Repeat don’t operate correctly.
✔ The space between the songs on the tape can’t be recognized
because it’s too short.
☞ Have at least 4 seconds between songs.
✔ The space between songs can’t be recognized because there’s too
much noise between songs.
46
☞ Reduce the noise between songs.
?
The blank skip doesn’t work.
47
✔ Because noise is too loud, the non-recorded part can’t be recognized.
☞ Reduce the noise between songs.
?
Blank Skip functions at places that are recorded.
48
✔ Because the recording level is low, it’s recognized as not recorded.
☞ Turn Blank Skip OFF.
?
✔ The power was turned OFF or a source selection or other operation
was performed.
☞ Music repeat is cancelled when the power is turned OFF or a
source selection or other operation is performed.
KRC-597(E)_U.S 03.10.7 6:48 PM Page 32