beautypg.com

Electrical connections for 3-wire system, Electrical connections for 4-wire system – Kenmore 417.64182300 User Manual

Page 2

background image

7

STRAIN

RELIEF

MOUNTING

BRACKET

NUT

TIGHTEN
NUT
TO THESE
THREADS

POWER
CORD

RED

WHITE

BLACK

TERMINAL BLOCK

SILVER TERMINAL

GREEN
GROUND
SCREW

GREEN POWER CORD
GROUND WIRE

GREEN
NEUTRAL
GROUND
WIRE

4. Thread a U.L. listed 30 amp power cord, NEMA 14-30

type ST or SRDT through the strain relief.

5. Attach the green power cord ground wire to the cabinet

with the green ground screw.

6. Attach the white (neutral) power cord conductor from the

power cord and the green ground wire from the dryer
harness (removed from the ground screw in step 3) to the
silver-colored center terminal on the terminal block. Tighten
the screw securely.

7. Attach the red and black power cord conductors to the

outer brass-colored terminals on the terminal block.

Do not make a sharp bend or crimp wiring/

conductor at the connections.

8. Tighten the screws securing the cord restraint firmly

against the power cord.

9. Tighten the strain relief nut securely so the strain relief

does not turn.

10. Reinstall the terminal block access cover.

TYPICAL 4
CONDUCTOR CORD

RED 240V

BLACK 240V

WHITE NEUTRAL

GREEN GROUND

30 AMP NEMA 14-30 TYPE SRDT OR ST

TYPICAL 4
CONDUCTOR
RECEPTACLE

POWER CORD

TIGHTEN NUT
TO THESE
THREADS

STRAIN
RELIEF
MOUNTING
BRACKET

GREEN
GROUND
SCREW

NUT

SILVER TERMINAL

GREEN
NEUTRAL
GROUND
WIRE

ELECTRICAL CONNECTIONS

FOR 3-WIRE SYSTEM

ELECTRIC Dryer

1. Remove the screws securing the terminal block access

cover and the strain relief mounting bracket located on the
back of the dryer upper corner.

2. Install a U.L. listed strain relief into the power cord entry

hole of the mounting bracket. Finger tighten the nut only at
this time.

3. Thread a U.L. listed 30 amp. power cord, NEMA 10-30

Type SRDT, through the strain relief.

4. Attach the power cord neutral (center wire) conductor to

the silver colored center terminal on the terminal block.
Tighten the screw securely.

5. Attach the remaining two power cord outer conductors to

the outer brass colored terminals on the terminal block.
Tighten both screws securely.

Do not make a sharp bend or crimp wiring/

conductor at connections.

6. Reattach the strain relief mounting bracket to the back of

the dryer with two screws. Tighten screws securely.

7. Tighten the screws securing the cord restraint firmly against

the power cord.

8. Tighten the strain relief nut securely so that the strain relief

does not turn.

9. Reinstall the terminal block cover.

ELECTRICAL CONNECTIONS

FOR 4-WIRE SYSTEM

ELECTRIC Dryer

1. Remove the screws securing the terminal block access

cover and the strain relief mounting bracket located on
the back of the dryer upper corner.

2. Install a U.L. listed strain relief in the entry hole of the

mounting bracket. Finger tighten the nut only at this time.

3. Remove the green neutral ground wire from the green

ground screw located above the terminal block.