Kenwood eXcelon KDC-X769 - Manual (Page 13)

3rd section
[2] button
Adjustment Item Display Range
Volume offset "V-Offset" –8 — ±0
Volume offset: Each source's volume can be set as a difference
from the basic volume.
[4] button
Adjustment Item Display Range
Loudness "LOUD" ON/OFF
[5] button
Adjustment Item Display Range
Non-Fading level "NF Level" –15 — +15
• Loudness: Compensating for low and high tones during low
volume.
• When the Dual Zone System is ON, the setting for the High Pass
Filter is nullified.
• ** Function of the KDC-X769
2nd section
[2] button
Adjustment Item Display Range
Front High Pass Filter ** "HPF F" Through/100/125/170 Hz
Rear High Pass Filter ** "HPF R" Through/200 Hz
Front/Rear
High Pass Filter "HPF" Through/100/125/170 Hz
[3] button
Adjustment Item Display Range
Non-Fading "LPF NF" 50/80/120/Through Hz
Low Pass Filter
[4] button
Adjustment Item Display Range
Treble Center
Frequency
**
"TRE F" 10.0/12.5/15.0/17.5 kHz
Treble level "Treble" –8 — +8
[5] button
Adjustment Item Display Range
Balance "Balance" Left 15 — Right 15
Fader "Fader" Rear 15 — Front 15
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the bass extend is set to ON, low frequency response is
extended by 20%.
• ** Function of the KDC-X769
— 13 —
KDC-MP822_U.S 02.12.11 11:23 AM Page 13