Kenwood KRC-609 - Manual (Page 8)

Press the upper side of the faceplate.
Holding the center part of the faceplate, pull it out.
Push back the bottom of the faceplate bracket until it locks.
• Do not apply excessive force to the faceplate bracket without
attaching the faceplate. Doing so will cause the faceplate
bracket to be deformed.
• Do not touch the connector on the faceplate bracket after
removing the faceplate. Touching the connector may cause
damage to the unit.
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts. For that reason, keep the faceplate
in its special storage case while detached.
• Do not expose the faceplate or its storage case to direct
sunlight or excessive heat or humidity. Also avoid places with
too much dust or the possibility of water splashing.
Reattaching the Faceplate:
Hold the faceplate so that the control panel faces the front
toward you and set the left side of the faceplate in the
faceplate bracket.
Do not set the right side of the faceplate in the faceplate bracket
first, when reattaching the faceplate. Doing so may cause the
2CAUTION
1
NOTE
2CAUTION
3
2
The faceplate can be reversed to hide the control panel or
detached form the unit, helping to deter theft.
Removing the Faceplate:
• When the control panel is visible:
Press the release button.
• When the control panel has been hidden:
1
Theft Deterrent Faceplate
Changing the Clock Display:
Each time you press the CLK button, the display switches
between the clock and each mode display.
The clock indicator lights while the clock is displayed.
NOTE
Clock display
This function allows you to adjust the setting that is recalled
with the System Q, according to types of speakers.
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
Press the Q button to enter the speaker setting mode.
Press either the 4 or ¢ button to select the type of
speaker. The setting switches as follows.
Off ("SP OFF") / For 6/6x9 in. speaker (“SP 6*9/6inch”) /
For 5/4 in. speaker (“SP 5/4inch”) /
For the OEM speaker (“SP O.E.M”)
Press the Q button to end the speaker setting mode.
Speaker setting function allows for tuning of bass, middle and
treble.
NOTE
4
3
2
1
Speaker Setting
General features
— 8 —
English
KRC-609_U.S 00.12.26 3:29 PM Page 8