Kenwood KRC-609 - Manual (Page 26)

English
— 26 —
Make sure that the unit is installed securely in place. If the unit
is unstable, it may malfunction (for example, the sound may
skip).
NOTE
Accessory2
Metal mounting
strap Self-tapping
screw
(commercially
available)
Firewall or metal support
Accessory6
Installation
■
Installation
6 mm
MAX.
M5mm M5mm
6 mm
MAX.
Installing in Japanese-Made Cars
■
T: Toyota cars
N: Nissan cars
T
N
N
T T/N
Accessory4...for Nissan car
Accessory5 ...for Toyota car
• During installation, do not use any screws except for those
provided. The use of different screws might result in damage
to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
2CAUTION
Refer to the section “Removing the hard rubber frame (P. 27)”
and then remove the hard rubber frame.
Mount the J-Car trim plate with the thick part at the
bottom.
Align the holes in the unit (two locations on each side) with
the vehicle mounting bracket and secure the unit with the
accessory screws. 3
2
1
4
5
Bend the tabs of the
mounting sleeve with
a screwdriver or
similar utensil and
attach it in place.
Accessory8
J-Car Trim Plate
(place thick part on
bottom)
KRC-609_U.S 00.12.26 3:29 PM Page 26