Kenwood TH-F6A - Manual (Page 35)

8 SELECTIVE CALL
30
DCS CODE ID SCAN
This function scans through all DCS codes to identify
the incoming DCS code on the received signal. You
may find this useful when you cannot recall the DCS
code that the other persons in your group are using.
1 While in DCS mode, press [F], [TONE] (1 s) to
start the DCS Code ID Scan function.
• To reverse the scan direction, turn the Tuning
control or press [ ]/ [ ].
• To quit the function, press [ ] or [PTT].
• When a DCS code is identified, the identified
code appears and blinks.
2 Press [ ] or [MNU] to program the identified
frequency in place of the current DCS code.
Otherwise, press [ ] if you do not want to
program the identified code.
• Turn the Tuning control or press [ ]/ [ ] while
the identified DCS code is blinking to resume
scanning.
Note:
◆ Received signals are monitored through the speaker while
scanning is in progress.
◆ DCS Code ID Scan does not scan the code if a signal is not
detected.
◆ If the DCS function is activated for both the A and B-band, the
scan speed may be slower.