Kenwood KDC-2031SA/G - Manual (Page 8)

8 | English
General features
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STBY" display.
2 Enter Speaker Setting mode
Press the [VOL] knob.
3 Select the Speaker type
Turn the [VOL] knob.
Each time the knob is turned, the setting
switches as shown below.
Speaker type Display
OFF "SP-F"
For 5 & 4 in. speaker "SP-5"
For 6x9 & 6 in. speaker "SP-6"
For the OEM speaker "SP-O"
4 Exit Speaker Setting mode
Press the [VOL] knob.
Clock Display
Press the [CLK] button.
Each time the button is pressed, the clock display
turns ON and OFF.
Adjusting Clock
1 Enter Standby
Press the [SRC] button.
Select the "STBY" display.
2 Select the clock display
Press the [CLK] button.
3 Enter clock adjustment mode
Press the [CLK] button for at least 2 seconds.
The clock display blinks.
4 Adjust the hours
Push the Control knob to [FM] or [AM].
Adjust the minutes
Push the Control knob to [
4] or [¢].
5 Exit clock adjustment mode
Press the [CLK] button.
Dimmer Control
You can change the unit's display to dimmer.
Press the [DIM] button for at least 1 second.
Each time the button is pressed for 1 second, the
Dimmer contol turns ON and OFF.
When it's ON, "on DI" is displayed.
DSI (Disabled System Indicator)
A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
1 Turn the power OFF
Press the [SRC] button for at least 1 second.
2 Set the DSI
While pressing the [1] and [3] button, press
the [SRC] button.
Release your fingers from the button after the
display is appeared.
Each time the step 1 and 2 operations are done,
the DSI turns ON and OFF.
Theft Deterrent Faceplate
The faceplate of the unit can be detached and
taken with you, helping to deter theft.
Removing the Faceplate
Press the Release button.
The faceplate is unlocked, allowing you to detach
it.
• The faceplate is a precision piece of equipment and
can be damaged by shocks or jolts. For that reason,
keep the faceplate in its special storage case while
detached.
• Do not expose the faceplate or its storage case to
direct sunlight or excessive heat or humidity. Also
avoid places with too much dust or the possibility of
water splashing.